Supplies Needed:

• CORRECT + Intensive Straightening Treatment

• Clarifying Shampoo

• Salt-free Shampoo

• Salt-free Hair Mask

• Bowl + Tinting Brush

• Tail Comb

• Recommendation - Salon heating device (Heating cap, Rollerball, infrared, or any lamp that generates just heat and not hot air or steam)

• Hairdryer

• Brush

• 4 Alligator Clips

• Professional Hair Straightener

• Clamp Comb – helps to maintain the tension that is critical to obtaining perfect results

 

The Process:

Let’s start with a diagnosis

We will distinguish between the following types of hair:

• NATURAL  - CURLY  HAIR

• WAVY HAIR – colored up to 7 levels of lift

• BLONDE HAIR – CLARIFIED

So you can determine the timing for the healing process and use of the straightener.

We recommend advising customers to come to the salon with their hair washed (only shampoo, no conditioner) and dried naturally so that you can see their hair in its most natural state.
 

​

Application And Waiting Time Table:

​

 

​

​

​

​

​

​

​

​

​

​

​

​

​

​

 

 

 

 

​

CORRECT+ ADVICE: Don’t let color, bleach, or other processes that the hair went through, confuse you. Any curly hair is still strong hair. Even if it has been lightened or highlighted, if the hair is still curly, then the hair is strong; treat it as such.

The straightening product must not come into contact with the scalp. CORRECT+ is not harmful to the skin, but never then less, it does contain active ingredients, and if it comes into contact with the skin, the customer might experience a tingly or itchy sensation. Again, though the product does not cause hair loss, following the application instruction precisely will assist in applying the product along with the hair without coming into contact with the scalp, which will protect you in case of a customer with unknown allergies or sensitive skin.

 

​

Step 1:

Wash  1-3  times with clarifying or deep cleansing shampoo; on the last wash, rinse after 5 minutes.

​

Step 2:

Dry the hair completely 100%.
Using a tinting brush, apply CORRECT+ at a distance of about an inch from the roots.
Using a rat tail comb, drag the product smoothly into the strands along the length of the hair until the end.

Use a LED heating lamp.

​

Step 3:

Divide the hair into four sections. Part a small row of hair (about 8 cm/ 3 inches in width) hold it at a 90° angle from the scalp and apply the “Correct+ Intensive Straightening Treatment” thoroughly half an inch from the root working it through the hair.

​

Step 4:

Wrap the hair in plastic wrap and wait for the time by the hair type. While waiting, it is essential to heat the area with a diffuser - if there is a heating machine, you do not need to wrap the hair.

​

Step 5:

Wet the hair with a cup of cold(fridge) water, massage the hair slightly, then rinse with cold water for a minute.

​

Step 6:

Dry the hair completely 100%.
Divide the hair into four even sections. Part the hair in a thin straight row (about 8 cm/ 3 inches in width), grasp it at a 90° angle with the clamp comb, and pull until there is tension.
Place the straightener as close to the scalp as possible without touching it.
Work in 5 cm/ 2 inches segments (in length), back and forth with a closed iron at all times, for 8-12 seconds, until achieving maximum shine and permanent change of the sulfur bonds structure.
Regarding the edges: If the edges are curly, iron according to section 4. However, if the edges are damaged, we straighten them lightly (depending on the condition of the edges). Suggests trimming the edges if it is in deplorable condition.

​

Step 7:

 Wait 10 minutes, then wash twice with salt-free shampoo.

 Next, apply a mask, wait 2 minutes and then rinse.

 Finally, dry the hair thoroughly to see the final result.

* At this point, it’s still possible to spot correct with the flat iron.

​

​

​

​

​

​

​

​

​